TimePilot Standard Specifications

LCD display

2 Lines x 16 alphanumeric characters.
Current date & time from PC displayed when station is idle.
Employee's name, last transaction date, time & In/Out status displayed when ID Button is touched to button reader.
Employee's name, current date, time & In/Out status displayed when IN, OUT, ON SITE or OFF SITE buttons are depressed.

Methods for clocking in/out

Momentary touch of Dallas iButton to reader followed by pressing IN or OUT.
Enter employee ID number via keypad followed by pressing IN or OUT (only if keypad is enabled).
Momentary touch of iButton to reader AND entry of employee 4-digit PIN number followed by pressing IN or OUT (most secure, but "PIN Number Security" must be enabled at the PC).

Multiple station capability

Multiple time clocks can be connected to different PCs in the same network and share the same database.
TimePilot Extreme, our weatherproof and wireless time and attendance system, and TimePilot PC, our software-only system, can be configured to work with TimePilot Standard on the same network to provide several options for clocking in and out.

Minimum user PC requirements

Pentium Class IBM-compatible PC.
256 megabytes of RAM.
100 megabytes of available disk space.
1 available USB port.
32-bit version of Windows 7, Windows Vista^TM, Windows XP (with Service Pack 2), Windows 2000, and Windows NT 4.0. Please note that TimePilot software will not run on 64-bit operating systems.
CD-ROM drive.

Station-to-station and station-to-PC cable

Cable doesn't need to be run in conduit.

4,000-foot maximum total cable length per network.

Noise immunity

Erroneous data is detected & rejected at both the system PC and the TimePilot station.

Power requirements

Unregulated 12-14 VDC @ 40 ma per station. Normally obtained from wall plug-in adaptor located at the system PC.
For very long network cable runs, several 12-14 VDC power sources can be connected to network cable at several locations.

Mechanical

Operating environment